This post is also available in:

Yesterday I “worked” (and filmed), and today you get to read about how I continued the 96K6 Pantsir-S1 build…

From this point on, unless otherwise stated or completely obvious, all abbreviations are written using the Latin alphabet.

After work, I stopped at the workshop – which, incidentally, is quite close to my office – intending to carry on with the model.

First, though, I had to clear the decks a little. We had played Vecna: Eve of Ruin the previous evening, and since it got late, we left everything as it was. So I had to rearrange some chairs and tables and set up the cameras and lighting. There went 45 minutes… Not that I’m complaining!

Anyway, on to the model. Of course, it wouldn’t be me if I hadn’t forgotten to glue on parts C22 and C23 last time 🤣

I glued them on and moved to step 5, determined that this time I would pay attention to the picture in the instructions and not forget any parts.

The step itself is very straightforward. The instructions are clear, and the parts fit together and onto the existing assembly without any problems, so there’s nothing particular to point out. For more detail, watch the video 😉

Of course, there were still a couple of interruptions: my colleagues in Argentina and Brazil interrupted me twice. But what can you do? These models cost money…

So, after around 45 minutes of work, I have made some progress:

And here is what the build looked like in real time – well, almost:

I left the workshop as it was and simply cleaned the table. I plan to continue tomorrow, and I hope the only preparation needed will be switching on the lights and cameras…